Attach the baffle to the plenum. Align the plenum using the threaded studs and fix in place using the nuts provided.
Next align the tray with the acrylic side panels using the slots and holes as shown.
Make sure that the panels are in the correct orientation before fixing in place.
Fix the tray to the side panels using M4 screws, M4 nuts and locking washers.
Align the Roof panel with the side panels using the slots and holes provided, and fix as before.
Fix in place using the M4 screws, nuts, and washers provided.
Position the plenum on the back panel of the hood, aligning the protruding screws with the slots.
Fix the plenum to the side panels using the M4 screws, M4 nuts and washers provided. This will require two people to hold the filter panel in place when securing.
Rotate the laminar flow hood and fix the filter panel to the metal tray to secure the structure.
Position and fix display screen to the front of the laminar flow hood, using the pilot holes to align it.
Slot in the HEPA filter, ensuring that the arrow is facing in the direction of air flow.
Make sure that the HEPA filter covers the entire plenum area.
Then secure the filter in place using the filter clamp screws.
Finally, screw the filter access panel in place.
Two people are needed to move the laminar flow hood into its desired location
Use the provided ethernet cable to connect the baffle to the display screen. The cable can be fed though one of the feedthrough holes in the back of the flow hood.
Finally, plug in the power cable, and switch the laminar flow hood on.
Now your laminar flow hood is ready to go.